The pinout diagram on the picture doesn't match my pinoccio boards!
The second pin (blue cable) should connect (according to the picture) SCK to SCK. But the second PIN on my pinnocios are labeled BKPK. Other pins are also wrong. So, what's right? My guess is that I should forget about the pins in the picture and just connect the PINs according to the labels on the diagram, correct?
Update: I just placed the target on the left and the programmer on the right, as in the picture and made the following connections using my pinoccio's labels:
Using this configuration of cables it didn't work. What I saw was:
Compiled on Dec 3 2015 at 16:09:05 with Arduino IDE 10605.
Attempting to enter programming mode ......................................................
Failed to enter programming mode. Double-check wiring!
Programming mode off.
Type 'C' when ready to continue with another chip ...
However, by looking at the code I see this part:
const byte RESET = SS; // --> goes to reset on the target board
const byte RESET = 10; // --> goes to reset on the target board
Is the picture also misleading? The picture's diagram tells us to connect the target (left) SS to the programmer RST (right) but the code seems to tell us the opposite. Can you, @Matthijs , confirm the correct connection pinouts?